Care Guide
Prior to using your new Detail Armory Car Detailing Brushes, we recommend taking each brush and gently pulling any loose bristles from the brush head. It's common to find some loose strands due to the manufacturing process and it is better to get them now rather than dealing with it later. After the initial grooming, you can use them regularly. Because detail brushes are reusable, they should be cleaned, dried, and left to air dry after each use.
Cleaning & Drying
After using the detail brush, simply clean the brush with water to rinse out any contaminants. If it's very dirty, use interior cleaner or diluted all-purpose cleaner along with water and clean the bristles with your fingers. Rinse it out with water until the water runs clear.
After rinsing, gently squeeze the bristles together to get excess water out.
Then "brush whip" the brush to remove any remaining water in the bristles.
Now, you can leave it out to air dry until the next time you use it again. There are several ways you can leave your brush out to air dry. One way is to place them into a holder to dry upright. This is probably the easiest way, but may take longer to dry.
The second way and probably the most effective at drying the brush is hanging them upside down. Since any residual water will drip off of the bristle tips, rather than stay inside the brush head, this will leave your brushes fully dried and will allow them to last longer. These brushes have a loop at the end, so you can either hang them on a hook or tie a string to allow them to hang off a variety of ways.